RevitMart Blog

What scan-to-BIM deliverables include

A laser scan is a point cloud. A scan-to-BIM deliverable is the Revit model, and sometimes the drawings, built from that cloud. The two are not the same file, and a proposal should say which one you are buying.

The cloud

Field scanning produces registered points: walls, floors, structure, and whatever MEP was visible from the scanner. You should receive the registered cloud in a format Revit can link, commonly RCP or E57, plus a note of how the scans were tied together. If the building was scanned on more than one day, the registration report matters. A model built on a cloud that does not close will be square in Revit and wrong on site.

The model

The Revit model traces the cloud to an agreed tolerance and an agreed level of development. Architectural scope is usually exterior walls, interior partitions, floors, roofs, doors, windows, stairs, and shafts. Structural scope adds columns, beams, and framing that the scan could see. MEP scope adds the duct, pipe, and equipment that were not hidden above a hard ceiling.

Hidden conditions stay hidden. A scanner does not see inside a wall or above a gypsum lid. The model should flag those areas instead of inventing them. Furniture, temporary protection, and people in the scan are not building elements and should not be modeled unless you ask for them.

The drawings

Many renovation jobs need sheets, not only the RVT. Floor plans, reflected ceiling plans, elevations, and a few sections, dimensioned from the model, are the usual as-built drawing set. Ask whether those sheets are included or priced after the model. Also ask for the Revit version, shared coordinates, and whether the cloud will be delivered linked into the model or as a separate file.

What to agree before the site visit

Write down the tolerance, the disciplines, the ceiling treatment, and whether the scan crew or your own surveyor controls the building. A model “accurate to the scan” with no number attached can mean half an inch or two inches. For a tenant fit-out, half an inch at the perimeter is usually what the architect needs. For a facility walkthrough, a coarser model is enough.

RevitMart scans and models, or models from a cloud you already have. The scan-to-BIM service states the file types before anyone sets up a tripod.

Contact Us